Re: FORD technical service bulletin : ICC touch screen display
|
|
False alarm! My apologies!
In a case of RTFM, if you pulse the FLMD0 pin it goes into different modes. 0 pulses is UART mode which I want. 8, 9, 11 & 12 pulses goes through the other interfaces that can be used.
Now, I've only got 2 hands, and I'm using alligator clips & wires on the smallest sewing needles I own here.
So I was releasing FLMD0 from +5v to open circuit so I could connect to the serial pins once powered up. Out with my "third hand" device (Jaycar "LED Magnifying lamp with third hand") to keep it at +5v...
And it's now programmed! Diags confirms my VIN from the EEPROM and Flash memory!
Sigh, now I need to pull my car apart again to test it all out (not today).
|