|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
25-03-2008, 12:38 AM
|
#1 | ||
|
yum
Join Date: Jan 2005
Posts: 1,417
|
Really this post is just to put some piccies of the seats out, just incase anyones planning on putting in an amp or similar, or at least know what to expect under their seat.
Preface: I'm a pretty messy person and over the last 2.5 years of owning the car I have had probably every single beverage known to man tip and spill out of the cup holders (which are almost always full of change). This made the carpet under the seats and on the transmission tunnel very sticky and crumbs became embedded in it. On Good Friday I went to Supercheap and got some carpet cleaner and got to work on the car. To remove the seats take the headrests off , bring the seatback to just more forward than vertical, and slide the seat forward so its centred on the rails. Using a 7mm socket, undo the locking bolt for the cable connections on the front of the seat, until the plug is free from the connectors. The mounting star bolts are (I think) T45 Torx. I got one previously from Repco. After removing the bolts, all you need to do is carefully manoevure the seat out the door, keeping and eye on the rear centre rail, its pokes out. While the seat is unmounted from the body, never lift the slide rail, makes reinstallation a headache. When putting the seats back in, screw the 4 bolts fingertight, then push the outside rail inwards, and tighten the 2 outside bolts fully. Then do the 2 inside bolts. My experience is if you don't do this, the rails become slightly misaligned. Reconnect the seat connector (or else you won't have side airbags or seatbelt pretensioners.) Some pics: Before:  After:  BTW those extra strands on cable aren't standard, it was for the blue LED lights under the seat.  More: http://img.photobucket.com/albums/v6...Photo-0389.jpg http://img.photobucket.com/albums/v6...Photo-0387.jpg http://img.photobucket.com/albums/v6...Photo-0386.jpg http://img.photobucket.com/albums/v6...Photo-0385.jpg http://img.photobucket.com/albums/v6...Photo-0383.jpg http://img.photobucket.com/albums/v6...Photo-0382.jpg http://img.photobucket.com/albums/v6...Photo-0381.jpg
__________________
2005 LS Focus LX
Nov05 | Manual | Black Sapphire 250,000kms. |
||
|
|
Took front seats out of the Focus
Threaded Mode