|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
24-05-2008, 07:15 PM
|
#1 | ||
|
Starter Motor
Join Date: May 2008
Posts: 3
|
Hi I have a 05 fiesta lx 1.6
It recently blew a radiator hose which resulted in it over heating. Immediately after this it was very hard to start, coughing and spluttering particulary when it was hot but had been off for about 10 minutes and then restarted. I suggested to the ford dealer that the head gasket had blown. The Ford dealer did a TK test and ruled out head gasket blown and detected fuel contamination. They attended to this replacing pump, rails, injectors and claimed the problem was fixed. Withing 30 minutes of picking up the car, it started doing the same thing, hard to start and steam pouring out the exhaust. Does any one have any advice ? Water is obviously getting into the system but the dealer says the TK test says that the head is ok. Thanks |
||
|
|
|
24-05-2008, 11:44 PM
|
#2 | ||
|
Regular Member
Join Date: Jun 2007
Posts: 175
|
the head must be warped or have a small crack in it, hmm allready a headgasket in a 05 fiesta god damn that aint good.
|
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
fiesta water getting in engine
Linear Mode
