|
06-12-2022, 12:05 AM | #10 | ||
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 21,247
|
Methodology, shown in a photo. I used my setter and a large vice to perform the task.
The plastic guide with metal pin, on the pin head side the guide’s cap snugly holds a quarter inch socket (shown with a spare guide). That provides strong, even backing support. On the counterbored side, the bullet tip ground onto my random bolt works with a little moly grease to spread the pin base as I clamp it all in a vice. I backed off the vice slightly and rotated the “setting tool” a one-third turn twice over. A much more calm-inducing approach than wallering away with a ball-pein hammer and the pin head precariously supported on a benchtop. |
||