|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
14-06-2006, 11:57 PM
|
#1 | ||
|
Starter Motor
Join Date: May 2006
Location: Jimboomba, QLD
Posts: 16
|
I have an AU2 ute, 5 speed manual, pacemaker extractors, lowered, other than that basically stock.
The thing is, is it accelerates like an absolute pig. Funny thing is, it is as torquey as anything, but I also own an EA 5 speed multipoint wagon which accelerates from a standing start to 100 a lot quicker. Like, one or two seconds. It also required less gear downshifting on hills etc. I have also owned an auto EL on LPG which was quicker too. At higher RPM it's not as bad. It's just at low RPM (up to 3500 rpm) its like it's totally bogged down. It's behaving almost like the timing is too far advanced or the leads are stuffed. But, as I have discovered, the ignition timing is not adjustable. The spark plugs (gapped correctly), oil, oil filter, leads and air filter are all brand new. The inlet manifold bolts were a little loose, but I tightened those but to no avail Any ideas would be much appreciated. thx |
||
|
|
|
15-06-2006, 12:05 AM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Dec 2004
Location: Melbourne, Victoria
Posts: 2,434
|
How many kms have you done? It could be worth, giving the intake a good clean. Especially the throttle body.
Your ute, should really pull!
__________________
AUIII Falcon Forte, with SIX Appeal |
||
|
|
|
|
15-06-2006, 12:29 AM
|
#3 | ||
|
Banned
Join Date: Jan 2005
Location: Beaumont Hills
Posts: 2,536
|
Check the accelerator cable isnt stretched it may need replacing aswell...
|
||
|
|
|
|
15-06-2006, 03:25 PM
|
#4 | ||
|
Starter Motor
Join Date: May 2006
Location: Jimboomba, QLD
Posts: 16
|
It's done 114,000kms. Accelerator cable is brand new too.
I'll give the throttle body a good clean out, see how it goes. |
||
|
|
|
|
15-06-2006, 10:27 PM
|
#5 | ||
|
Banned
Join Date: Aug 2005
Posts: 2,017
|
how did you go mate?
|
||
|
|
|
|
16-06-2006, 01:15 PM
|
#6 | ||
|
Starter Motor
Join Date: May 2006
Location: Jimboomba, QLD
Posts: 16
|
I'll pull it apart next week and have a go.. will keep u posted!
|
||
|
|
|
HELP! AU 5-speed accelerating like a pig
Linear Mode
