|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| FPV & XR Club of Victoria Discussions FPV & XR Club of Victoria Discussions |
 |
|
|
Thread Tools | Display Modes |
29-08-2007, 03:34 PM
|
#1 | ||
|
Racing improves the breed
Join Date: Apr 2006
Location: SE Melbourne
Posts: 3,981
|
Hi guys, I have just been on the FPV & XR website looking through a few of the motorsport photos and noticed that pretty much everyone was using the same type of bonnet catch located on the side of the bonnet and front quarter panel. I have lost my current catch and was wondering where everyone gets theirs from. Thanks, Steve
__________________
1970 Mini Cooper S Historic Group Nc Touring car 1964 Mini Cooper S Historic Group Nb Touring car Victorian Hill Climb Championship |
||
|
|
|
29-08-2007, 04:46 PM
|
#2 | ||
|
Just cruizin' around.....
Join Date: Nov 2006
Location: In the Garage
Posts: 326
|
Hey Steve , I will be back home on Friday and can take a couple of Piccies and then put them up both here and on the website if you can wait until then....
But I bought 2x50mm brackets from Bunnings (Church) and as the holes were positioned perfectly I simply bent them up to the same profile as the guard from the first bolt hole. Then got a small piece of metal (rubber backed to protect the paint) with a slot in the middle to go over the bracket and a split pin to go through the top hole outside of the bonnet (when shut) to keep it closed. Repeat for the other side and there you have it - an acceptable secondary bonnet restraint to complete with that can be taken on/off the car in 20secs with no modification to any part of the car.
__________________
Proud Member of....... Last edited by MOTIV8; 29-08-2007 at 04:52 PM. |
||
|
|
|
Bonnet catches
Linear Mode
