![]() |
|
![]() |
#1 | ||
Starter Motor
Join Date: Mar 2006
Posts: 1
|
Please be kind - I am new here - but can anyone tell me how to remove the radio from a 1997 laser?
Any advice much appreciated. Brew |
||
![]() |
![]() ![]() |
![]() |
#2 | ||
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
can you post a pic of the setup in your car
if its in the dash then there is a lot of plastic intertior to undo you might break something or mix up the wiring ? sure you dont want to leave it to a car radio fitter ( yellow pages )?
__________________
My car goes Brumm Brumm |
||
![]() |
![]() ![]() |
![]() |
#3 | ||
Starter Motor
Join Date: Jan 2006
Posts: 8
|
On either side of the front face of the radio, there are black plastic bits of trim.
Remove these by sliding them off the front of the radio. Underneath them is 4 holes that you put a small rod down to release the metal clips that hold the radio in place. Obviously you will have to remove all the wiring/aerial from the back of the radio before pulling it out fully. |
||
![]() |
![]() ![]() |
![]() |
#4 | ||
Starter Motor
Join Date: Oct 2006
Posts: 4
|
![]() |
||
![]() |
![]() ![]() |